1.Air purifier
The air filter is the component that removes dust and grime from the air. The screw rotor compression chamber is filled with filtered clean air. If the air filter becomes clogged and broken, particles bigger than the permissible size enter the screw circulation, which not only reduces the life of the oil core. The oil micro-separation core's service life can also cause a significant number of particles to enter the bearing hole directly, accelerating bearing wear, increasing rotor clearance, decreasing compression efficiency, and boringly biting the rotor. The rotor was also bitten.
2. The oil filter
After 500 hours of operation, the new machine must change the oil core and spin the oil filter with a specific tool to remove it. Screw oil should be used after the replacement core. With both hands, turn the oil filter and firmly tighten the oil filter seal. It is advised that the oil filter be replaced every 1500-2000 hours.
3.Separator
The oil-air separator is a component used in the separation of lubricating oil and compressed air. During typical operation, the oil and gas separator has a service life of roughly 3000 hours, but the quality of the lubricating oil and the precision of the air filtration have a significant impact on the service life. As a result, in a rigorous usage environment, the air filter maintenance and replacement cycle must be reduced, and even the air filter before installation must be considered. The oil and gas separator must be changed when it expires or when the pressure differential between the front and rear exceeds 0.12mpa. Otherwise, the motor may be overworked, causing the oil separator to be destroyed and allowing the oil to flow.
